handmade and vintage goods

Photo by Erik Valind

Every family and friend group has its resident shutterbug. A designated or self-appointed someone who shows up to every special occasion—a backyard barbecue, birthday bash, or Sunday brunch bonanza—with their camera in tow, and spends much of the day stealthily shooting away. In the moment, we might find ourselves rolling our eyes or feigning exasperation when asked to “smile!” for yet another group shot—but the memories captured are truly priceless, and we know we’re lucky to have them.

Explore DIYs

Whether your personal photographer-in-chief is your dad or your best friend (or if you’re the one behind the lens!), every photog deserves a stylish camera strap to keep their most prized possession safe and secure—and within arm’s reach. There are tons of great options available on Etsy of course, but if you’re up for a simple DIY project, you can create a custom one at home in a snap. Using a length of vintage-style trim, a couple scraps of durable leather, and a few hardware pieces to hold it all together, we’ll show you how it’s done.

At a glance

Time: 2 hours

Difficulty: Intermediate

You will need:

Step 1: Determine length of strap

Drape the fabric trim around your neck to determine how long you want to make your strap. Add 4 inches to this length and cut.

Step 2: Slide trim through swivel clasp

Take one end of your length of trim and fold the corners in, toward the center. Slide the folded end through one of the swivel clasps so about 2 inches of trim are poking out.

Step 3: Stitch end in place

Fold the short end of the trim onto the backside of the strap and baste stitch near the edge to secure it in place. Repeat all three steps for the other end of the strap and set it aside.

Step 4: Cut leather strip

Cut a rectangular strip of leather that’s about 3 inches long and 1/2 inch narrower than the width of your trim.

Step 5: Measure and trim leather to size

Fold the piece of leather in half. Center your second swivel clasp above the folded edge and use a pen to mark the width of the D-ring on both sides of the leather fold.

Keeping the leather folded, cut an angled line from one bottom corner of the strip to the pen mark you made on the nearest folded edge. Repeat on the other side, then use scissors to round the outer edges.

Step 6: Trace and repeat

Trace the cut leather shape onto a second piece of leather and cut an identical piece for the other side of your camera strap.

Step 7: Add leather to trim

Grab your strap and, holding one of the sewn ends, slide one of the cut leather pieces through the D-ring and fold it over the trim.

Step 8: Punch holes for rivets

Use the mallet and leather hole punch to punch three holes through all the layers of the folded leather and trim near each end of the strap: one in the center near the D-ring, and one near each bottom corner.

Step 9: Set rivets and repeat

Position a rivet in each hole and use the mallet and rivet setter to set.

Project by Julie O’Boyle, Aleksa Brown, and Clare McGibbon. Photographs courtesy of Erik Valind.

Shop DIYs

Katie Hawley is a senior editor at Etsy. She’s also an aspiring weaver, a perpetual snacker, and head-over-heels obsessed with her dog.

The post Make a Custom Camera Strap appeared first on Etsy Journal.


Movenpick Many GEOs