Hello Remodelaholics! Sarah here from The Created Home, where we never throw things away, we just turn them into something else. Recently, my husband and I pulled a few solid core interior doors from a home we are flipping, and when another home needed a barn door for the laundry closet it was like the heavens opened and choirs sang and we knew.
I mean, most of the cost of DIY is in the lumber, right? So why not start with a door and add little here and there to make your own door?
There are a lot of ways to design a barn door, so if you are not loving the herringbone-style chevrons (but really, who doesn’t love chevron?!) you can take this idea and change it up however you like.
How to Make a DIY Barn Door from an Interior Door
Here’s what you will need for this project:
A door (solid core is best)
1×4 lumber – this project required 4 eight foot boards
1/4″ luan plywood (if filling in a design between the outlines)
wood glue
paint or stain – this is Demo Day from Magnolia
sliding barn door hardware*, plus optional spacers
wood filler
*See the full Remodelaholic Guide to Budget-Friendly Barn Door Hardware here — starting at $70!
Tools
miter saw
circular saw
table saw
brad nailer (optional)
clamps
trim router (optional)
How to turn an old interior door into a fabulous sliding barn door
Step 1: Remove the door hinge mortises.
I removed them with a circular saw and a guide, cutting away about 1/4″ of material. If you prefer not to cut off material you can also fill them in with some filler or Bondo.
Step 2:Cut outer frame pieces (sides).
Lay the long pieces on the door where you want them and mark a cut line. Marking instead of measuring creates easy, accurate lines. Cut and then glue down the pieces. Clamp in place.
Step 3: Cut inner frame pieces (top and bottom), as well as middle column piece.
Make sure to get a good, tight fit. Glue and clamp.
Step 4: Rip 1/4″ plywood into strips.
Mine are about 4″ wide. I used the table saw to make this happen quickly.
Step 5: Cut a 45 degree angle at the end of each piece to be inlay-ed into your frame.
Be sure not to cut them to short. The angle means they need to be longer than you might think!
Step 5.5: Round the edges (optional)
I chose to slightly round over each piece so that they would create uniform spacing.
In this photo you can see the pieces without the round over.
This photo shows how the pieces look with the round over. I simply used a trim router and zipped through the sides (not the angled ends). It’s not essential, but it’s a nice touch.
Step 6: Mark and cut each piece at the other end to fit tightly into the frame.
Glue in place and use brad nails to tack them down or weights to hold them in place while drying.
Step 7: Fill any gaps at the side of the door to make it look as seamless as possible.
You can use Bondo if you are painting. Sand smooth.
Paint or stain as desired.
Step 8: Hang with barn door hardware according to manufacture instructions.