Have you ever made a fabric covered notebook? I bought a fun new gadget, The Cinch binding tool, to play with and thought I’d share an easy way to make custom notebooks and use up fabric scraps to make it fancy! I’m brainstorming ways to make special notebooks as gifts for my kids, with blank comic book sheets, handwriting lines, and more.
This post was sponsored by, which means they supplied some of the materials and compensated me for my time, but all opinions are my own.
Isn’t this fun?! It’s so nice to have a different visual than the stereotypical gray-haired guy in a lab.
I filled this one up with watercolor paper so we can take it out and about as a little nature journal, but the options are endless. If you’re gifting one, try pairing it with a set of , , or ! My kids love drawing but get mad when the dog runs over their loose papers or they get misplaced, so notebooks are a lifesaver.
Pin this fabric covered notebook tutorial for later or photo:
How to make a diy fabric covered notebook
Ready to make your own?
Supplies
- Fat quarter sized fabric scraps – I used this
- Thick cardboard sheets – I reused cardboard from a mailer I got, mine were 5.5″ wide X 10″ tall
- Coil binding
- Wire cutters
- Paintbrush
- Rotary cutter + quilt ruler
- Brayer or credit card/smoothing tool
- Scissors & ruler or
Steps
Step 1- Apply a thin layer of mod podge fabric to one side of the cardboard and lay your scrap over top. Use a credit card or a brayer to smooth it out flat.
Step 2- Layer it with something non-stick, these are cheapie cutting boards but you could use plastic, parchment paper, etc. and stack some heavy stuff on top so it dries flat.
Step 3- Once it has dried, flip it over and trim along the edges so it is flush with the cardboard.
Step 4– Time to punch holes! The Cinch gives you a little guideline for which pegs to pull out and give you a nice neat line, I just followed their instructions. Repeat steps 1-4 for the back cover.
Step 5– Cut your matching insert pieces! I used watercolor paper but you can pick whatever you want inside.
Step 6– Time to bind! Again, the machine’s instructions are clear and easy, you just insert the paper on the wires and then smoosh to close.
Step 7- Trim off any excess binding with wire cutters and you’re done!
The post appeared first on .
